To be mounted in a corner hanging on a wall.
Fit the rear piece vertically with the bottom edge 100-200
mm above floor level.
Connect the duct to the unit.
Push the top duct cover sheet plate to the ceiling and screw
it to the unit back plate. The top plate should fit inside the
outer duct cover.
Hang the unit front on the back plate and screw it to the side
rails with the screws that are concealed in the side rails.
Use the special screwdriver that is included with the unit
delivery.
Measuring tubes and adjusting cord for the damper should
protrude through the side rails holes.

The unit is supplied with a measuring unit and a adjusting
damper. The damper cord and measuring tubes are
concealed in the side rail.
When the adjustment has been completed the cord should
be pressed into the unit through the hole. The cord can be
pulled out at a later stage by removing the unit front.
The near zone can be adjusted by a near zone regulator.
These accessories can be fitted at any time.
The unit can be cleaned internally by removing the front
plate and the cleaning port on the internal duct opened.

Clean with water and a mild detergent solution.