Assembly etc.
To be recessed in a wall.
Fit the wall duct to the unit whilst laid out on the floor.
Seal the telescopic joint in the wall duct.
The unit and duct should normally fit in between two
wooden battens.
The bottom edge should be aprox 150 mm above floor level.
Adjustment, cleaning
The airflow should be adjusted by an externally mounted damper in the ductwork. The unit can be cleaned in vertically by removing the front panel.

Maintenance
Clean with water and a mild detergent solution.

The unit box is recessed
into the wall and screwed
to the wooden battens.The
mounting frame will cover
the gap around the unit
box.The front panel is
screwed to the mounting
frame after the wall
has been painted.
The unit box is to be fitted
at a height of aprox 150
mm above floor level.